PICS 1-3
:
Arches
were sprayed with Halfords grey primer, give them a couple of coats until you
get a nice even layer.
PICS 4-9:
Using a
50:50 mix of Dawnstone and Administratum Grey (Any mid- grey and light grey mix
will do. Airbrush on a random pattern.
Once dry
use pure Administratum Grey and airbrush within the existing pattern so that it
gives a nice transition
Once dry
apply a final highlight of 30:70 Administratum Grey and White within the
previous layer so that you are working in a smaller and smaller area
PICS
10-15
Weathering
using W&N oils
I used
Ivory Black, Burnt Umber and Sap Green. Ivory Black is applied to the curved
arches, the uprights at either end and across the top of each section. Use an
old drybrush for this. Dip in the paint wipe off some of the excess then apply
the oil to the building, I then use a seperate brush dipped in White Spirit to
thin out the black by washing over it and blend it into the grey below. It will
probably take a couple of goes to thin it out. Don't worry about flooding the
area as the White Spirit as it will soon evaporate.
I used
Sap Green along the bottom of the walls and on the pavement using the same
technique as above.
Burnt
Umber was used in patches between the black and green just for a bit of
variation.
Allow the
oils to dry overnight.
When dry
I sprayed them with dullcoat to seal everything before the next stage.
PICS
16-23
Apply
tranfers and posters and tags. For the transfers I used micro sol/micro set,
the transfers are from Multiverse Gaming, the posters are from the PDF file
from this group. If you don't seal the oils, when you apply micro sol it will
dilute the oils and ruin the blend (learnt from experience lol).
I dipped
the posters into water to soften them slightly (personal preference) then brush
on watered down PVA glue to the reverse of the poster, fixed into place on the
building and then applied the same glue to the front of the poster. For some of
them I'd screw them up when softened to get some creases then apply the glue.
Once the glue is dry you can add some extra grime with a layer of nuln oil or
weathering powders. For the tags I used an acrylic paint pen and found some
random tags online to copy.
PICS
24-25
Snow
& Ice was created using Secret Weapon crushed glass set and applied
directly onto the arches, really easy to use.
No comments:
Post a Comment